||
Skip to end of metadata
Go to start of metadata

Use the tips give below to troubleshoot the LVS Load Balancer:

  • Use the command shown below to find the syslogs related to the Keepalived: 

    $tail -f /var/log/syslog
  • Check the configured VIP addresses for eth0 using the ip addr list command. 
    Example output:

    1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default
    	link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    	inet 127.0.0.1/8 scope host lo
       	valid_lft forever preferred_lft forever
    	inet6 ::1/128 scope host
       	valid_lft forever preferred_lft forever
    2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP group default qlen 1000
    	link/ether fa:16:3e:d3:09:4a brd ff:ff:ff:ff:ff:ff
    	inet 192.168.30.24/24 brd 192.168.30.255 scope global eth0
       	valid_lft forever preferred_lft forever
    	inet 192.168.30.30/32 scope global eth0
       	valid_lft forever preferred_lft forever
    	inet6 fe80::f816:3eff:fed3:94a/64 scope link
       	valid_lft forever preferred_lft forever
    
  • If you are unable to connect to the server, you can telnet to the VIP and port.

    During failover, it is normal to expect a delay in the new connection establishment, until the slave node takes control. The delay depends on the load, on the cluster. Therefore it will take several minutes.

    $telnet 192.168.30.30 8080

    If telnet reports no route to host, recheck the keepalived.conf configuration file, which is in the the <KEEPALIVEID_HOME>/etc/keepalived directory to make sure that you have entered the correct VIP and RIPs.

 

  • No labels