All docs This doc

Versions Compared


  • This line was added.
  • This line was removed.
  • Formatting was changed.


Error Code Detail
101000Receiver input/output error sending
101001Receiver input/output error receiving
101500Sender input/output error sending
101501Sender input/output error receiving
101503Connection failed
101504Connection timed out (no input was detected on this connection over the maximum period of inactivity)
101505Connection closed
101506NHTTP protocol violation

Connection canceled

101508Request to establish new connection timed out
101509Send abort
101510Response processing failed

If the HTTP PassThrough transport is used, and a connection level error occurs, the error code is calculated using the following equation:

Code Block
Error code = Base error code + Protocol State

There is a state machine in the transport sender side, where the protocol state changes according to the phase of the message.

Following are the possible protocol states and the description for each:

Protocol StateDescription
REQUEST_READY (0)Connection is at the initial stage ready to send a request
REQUEST_HEAD(1)Sending the request headers through the connection
REQUEST_BODY(2)Sending the request body
REQUEST_DONE(3)Request is completely sent
RESPONSE_HEAD(4)The connection is reading the response headers
RESPONSE_BODY(5)The connection is reading the response body
RESPONSE_DONE(6)The response is completed
CLOSING(7)The connection is closing
CLOSED(8)The connection is closed

Since there are several possible protocol states in which a request can time out, you can calculate the error code accordingly using the values in the table above.

For example, in a scenario where you send a request and the request is completely sent to the backend, but a timeout happens before the response headers are received, the error code is calculated as follows:

In this scenario, the base error code is CONNECTION_TIMEOUT(101504) and the protocol state is REQUEST_DONE(3).


Error code = 101504 + 3 = 101507

Endpoint failures

This section describes the error codes for endpoint failures. For more information on handling endpoint errors, see Endpoint Error Handling.