Note how the ERROR_MESSAGE property is being used to get the error message text. If you want to customize the error message that is sent back to the client, you can use the makefault mediator as demonstrated in Sample 5: Creating SOAP Fault Messages and Changing the Direction of a Message.
Anchor codes codes
This section describes error codes and their meanings.
Transport error codes
|101000||Receiver input/output error sending|
|101001||Receiver input/output error receiving|
|101500||Sender input/output error sending|
|101501||Sender input/output error receiving|
|101504||Connection timed out (no input was detected on this connection over the maximum period of inactivity) |
|101506||NHTTP protocol violation|
|101508||Request to establish a new connection timed out|
|101510||Response processing failed|
If the HTTP PassThrough transport is used, and a connection level error occurs, the error code is calculated using the following equation:
Error code = Base error code + Protocol State
There is a state machine in the transport sender side, where the protocol state changes according to the phase of the message.
Following are the possible protocol states and the description for each:
|REQUEST_READY (0)||Connection is at the initial stage ready to send a request|
|REQUEST_HEAD(1)||Sending the request headers through the connection|
|REQUEST_BODY(2)||Sending the request body|
|REQUEST_DONE(3)||Request is completely sent|
|RESPONSE_HEAD(4)||The connection is reading the response headers|
|RESPONSE_BODY(5)||The connection is reading the response body|
|RESPONSE_DONE(6)||The response is completed|
|CLOSING(7)||The connection is closing|
|CLOSED(8)||The connection is closed|
Since there are several possible protocol states in which a request can time out, you can calculate the error code accordingly using the values in the table above.
For example, in a scenario where you send a request and the request is completely sent to the backend, but a timeout happens before the response headers are received, the error code is calculated as follows:
In this scenario, the base error code is
CONNECTION_TIMEOUT(101504) and the protocol state is
Error code = 101504 + 3 = 101507
This section describes the error codes for endpoint failures. For more information on handling endpoint errors, see Endpoint Error Handling.
|303000||Load Balance endpoint is not ready to connect|
|303000||Recipient List Endpoint is not ready|
|303000||Failover endpoint is not ready to connect|
|303001||Address Endpoint is not ready to connect|
|303002||WSDL Address is not ready to connect|
Failure on endpoint in the session
|309001||Session aware load balance endpoint, No ready child endpoints|
|309002||Session aware load balance endpoint, Invalid reference|
|309003||Session aware load balance endpoint, Failed session|
|303100||A failover occurred in a Load balance endpoint|
|304100||A failover occurred in a Failover endpoint|
Referring real endpoint is null
|305100||Indirect endpoint not ready|
Callout operation failed
|401000||Callout operation failed (from the callout mediator)|
|401001||Blocking call operation failed (from the Call mediator when you have enabled blocking in it).|
|401002||Blocking sender operation failed (from the Call mediator when you have enabled blocking in it).|
Custom error codes
Endpoint Custom Error - This error is triggered when the endpoint is prefixed by
enhances the failover logic by marking an endpoint as suspended when the response is a SOAP fault.
For information on best practices for handling errors in WSO2 ESB, see WSO2 ESB by Example - Best practices for error handling on the WSO2 ESB.